Siemens SINAMICS S110 List Manual page 31

Note: Procedure:
1.
The parameter number to be displayed should be set in index 0. Only the monitoring parameters (read-only param-
eters) can be set that actually exist for the actual drive object.
If the set parameter number is not indexed, or if there is an index in index 1 that lies outside the valid range of the
set parameter, then index 1 is automatically set to 0.
2.
The index that belongs to the parameter set in index 0 should be set in index 1. The permissible changes in index 1
always depend on the parameter number set in index 0.
p0006 BOP operating display mode / BOP op_ disp mode
CU_S110-CAN, Can be changed: U, T
CU_S110-DP,
Data type: Integer16
CU_S110-PN
P-Group: -
Not for motor type: -
Min
4
Description: Sets the mode of the operating display for the Basic Operator Panel (BOP) in the operating states "ready for opera-
tion" and "operation".
Value: 4:
Dependency: Refer to: p0005
Note: Mode 0 ... 3 can only be selected if also r0020, r0021 are available on the drive object.
Mode 4 is available for all drive objects.
p0006 BOP operating display mode / BOP op_ disp mode
SERVO_S110-CAN, Can be changed: U, T
SERVO_S110-DP,
Data type: Integer16
SERVO_S110-PN
P-Group: -
Not for motor type: -
Min
0
Description: Sets the mode of the operating display for the Basic Operator Panel (BOP) in the operating states "ready for opera-
tion" and "operation".
Value: 0:
1:
2:
3:
4:
Dependency: Refer to: p0005
Note: Mode 0 ... 3 can only be selected if also r0020, r0021 are available on the drive object.
Mode 4 is available for all drive objects.
p0007 BOP background lighting / BOP lighting
CU_S110-CAN, Can be changed: U, T
CU_S110-DP,
Data type: Unsigned32
CU_S110-PN
P-Group: -
Not for motor type: -
Min
0 [s]
Description: Sets the delay time until the background lighting of the Basic Operator Panel (BOP) is switched off.
If no keys are actuated, then the background lighting automatically switches itself off after this time has expired.
Note: p0007 = 0: Background lighting is always switched on (factory setting).
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
p0005
Operation --> r0021, otherwise r0020 <--> r0021
Operation --> r0021, otherwise r0020
Operation --> p0005, otherwise p0005 <--> r0020
Operation --> r0002, otherwise r0002 <--> r0020
p0005
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
4
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
4
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
2000 [s]
Parameter
List of parameters
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
4
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
4
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0 [s]
1-31