Siemens SINAMICS S110 List Manual page 17

Calculated
Specifies whether the parameter is influenced by automatic calculations.
The calculation attribute defines which activities influence the parameter.
The following attributes apply:
• CALC_MOD_ALL
− p0340 = 1
− Project download with commissioning software and send from p0340 = 3
• CALC_MOD_CON
− p0340 = 1, 3, 4
• CALC_MOD_EQU
− p0340 = 1, 2
• CALC_MOD_LIM_REF
− p0340 = 1, 3, 5
− p0578 = 1
• CALC_MOD_REG
− p0340 = 1, 3
Note:
For p3900 > 0, p0340 = 1 is also called automatically.
After p1910 = 1, p0340 = 3 is also called automatically.
Access level
Specifies the access level required to be able to display and change the relevant
parameter. The required access level can be set via p0003.
The system uses the following access levels:
1. Standard
2. Extended
3. Expert
4. Service
Parameters with this access level are password protected.
Note:
Parameter p0003 is CU-specific (present on Control Unit).
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Parameter
Overview of parameters
1-17