Siemens SINAMICS S110 List Manual page 657

r20047 BO: OR 0 output Q / OR 0 output Q
CU_S110-CAN, Can be changed: -
CU_S110-DP,
Data type: Unsigned32
CU_S110-PN,
P-Group: -
SERVO_S110-CAN
Not for motor type: -
(FBLOCKS),
SERVO_S110-DP
(FBLOCKS),
SERVO_S110-PN
(FBLOCKS)
Min
-
Description: Display parameter for binary quantity Q = I0 | I1 | I2 | I3 of instance OR 0 of the OR function block.
p20048 OR 0 run-time group / OR 0 RTG
CU_S110-CAN, Can be changed: T
CU_S110-DP,
Data type: Integer16
CU_S110-PN,
P-Group: -
SERVO_S110-CAN
Not for motor type: -
(FBLOCKS),
SERVO_S110-DP
(FBLOCKS),
SERVO_S110-PN
(FBLOCKS)
Min
0
Description: Setting parameter for the run-time group in which the instance OR 0 of the OR function block is to be called.
Value: 0:
1:
2:
3:
4:
5:
6:
7:
8:
9:
9999: Do not calculate
p20049 OR 0 run sequence / OR 0 RunSeq
CU_S110-CAN, Can be changed: T
CU_S110-DP,
Data type: Unsigned16
CU_S110-PN,
P-Group: -
SERVO_S110-CAN
Not for motor type: -
(FBLOCKS),
SERVO_S110-DP
(FBLOCKS),
SERVO_S110-PN
(FBLOCKS)
Min
0
Description: Setting parameter for the run sequence of instance OR 0 within the run-time group set in p20048.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Run-time group 0
Run-time group 1
Run-time group 2
Run-time group 3
Run-time group 4
Run-time group 5
Run-time group 6
Run-time group 7
Run-time group 8
Run-time group 9
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
-
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
9999
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
32000
Parameter
List of parameters
Access level: 1
Func. diagram: 7212
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 1
Func. diagram: 7212
Unit selection: -
Expert list: 1
Factory setting
9999
Access level: 1
Func. diagram: 7212
Unit selection: -
Expert list: 1
Factory setting
60
1-657