Siemens SINAMICS S110 List Manual page 185

1011: Save in volatile memory, downloaded with p0976=1011
1012: Save in volatile memory, downloaded with p0976=1012
1013: Save in volatile memory, downloaded with p0976=1013
Dependency: Refer to: p0976, p1960
Caution: Memory card inserted:
The drive parameterization is also saved on the card. Any backed-up data is overwritten!!!
Caution: The Control Unit power supply may only be powered down after data has been saved (i.e. after data save has been
started, wait until the parameter again has the value 0).
Notice: Writing to parameters is inhibited while saving.
The progress while saving is displayed in r3996.
Note: Parameters saved with p0977 = 10, 11 or 12 can be downloaded again with p0976 = 10, 11 or 12.
r0979[0...30] PROFIdrive encoder format / PD encoder format
SERVO_S110-CAN, Can be changed: -
SERVO_S110-DP,
Data type: Unsigned32
SERVO_S110-PN
P-Group: Encoder
Not for motor type: -
Min
-
Description: Displays the actual position encoder used according to PROFIdrive.
Index: [0] = Header
[1] = Type, encoder 1
[2] = Resolution enc 1
[3] = Shift factor G1_XIST1
[4] = Shift factor G1_XIST2
[5] = Distinguishable revolutions encoder 1
[6] = Reserved
[7] = Reserved
[8] = Reserved
[9] = Reserved
[10] = Reserved
[11] = Type, encoder 2
[12] = Resolution enc 2
[13] = Shift factor G2_XIST1
[14] = Shift factor G2_XIST2
[15] = Distinguishable revolutions encoder 2
[16] = Reserved
[17] = Reserved
[18] = Reserved
[19] = Reserved
[20] = Reserved
[21] = Reserved
[22] = Reserved
[23] = Reserved
[24] = Reserved
[25] = Reserved
[26] = Reserved
[27] = Reserved
[28] = Reserved
[29] = Reserved
[30] = Reserved
Note: Information about the individual indices can be taken from the following literature:
PROFIdrive Profile Drive Technology
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
-
Parameter
List of parameters
Access level: 3
Func. diagram: 4010, 4704
Unit selection: -
Expert list: 1
Factory setting
-
1-185