Siemens SINAMICS S110 List Manual page 294

Parameter
List of parameters
Notice: Where there is a multiple interconnection of a connector output, all the connector inputs must either have Integer or
FloatingPoint data types.
A BICO interconnection for a single PZD can only take place either on r2050 or r2060.
Note: IF1: Interface 1
p2051[0...20] CI: IF1 PROFIdrive PZD send word / IF1 PZD send word
CU_S110-CAN, Can be changed: U, T
CU_S110-DP,
Data type: Unsigned32 / Integer16
CU_S110-PN
P-Group: Communications
Not for motor type: -
Min
-
Description: Selects the PZD (actual values) with word format to be sent to the PROFIdrive controller.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
[8] = PZD 9
[9] = PZD 10
[10] = PZD 11
[11] = PZD 12
[12] = PZD 13
[13] = PZD 14
[14] = PZD 15
[15] = PZD 16
[16] = PZD 17
[17] = PZD 18
[18] = PZD 19
[19] = PZD 20
[20] = PZD 21
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
Note: IF1: Interface 1
p2051[0...27] CI: IF1 PROFIdrive PZD send word / IF1 PZD send word
SERVO_S110-CAN, Can be changed: U, T
SERVO_S110-DP,
Data type: Unsigned32 / Integer16
SERVO_S110-PN
P-Group: Communications
Not for motor type: -
Min
-
Description: Selects the PZD (actual values) with word format to be sent to the PROFIdrive controller.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
[8] = PZD 9
[9] = PZD 10
[10] = PZD 11
[11] = PZD 12
[12] = PZD 13
1-294
Calculated: -
Dynamic index: -
Units group: -
Scaling: 4000H
Max
-
Calculated: -
Dynamic index: -
Units group: -
Scaling: 4000H
Max
-
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 3
Func. diagram: 2470
Unit selection: -
Expert list: 1
Factory setting
0