Siemens SINAMICS S110 List Manual page 128

Parameter
List of parameters
- p2175 = factory setting
- p2177 = factory setting
p0505 Selecting the system of units / Unit sys select
SERVO_S110-CAN, Can be changed: C2(5)
SERVO_S110-DP,
Data type: Integer16
SERVO_S110-PN
P-Group: Applications
Not for motor type: -
Min
1
Description: Adjustable parameter of the actual system of units.
Value: 1:
2:
3:
4:
Dependency: The parameter cannot be changed if the master control was fetched.
Caution: If a per unit representation is selected and if the reference parameters (e.g. p2000) are subsequently changed, then
the physical significance of several control parameters is also adapted at the same time. As a consequence, the
control behavior can change (see p1576, p1621, p1744, p1752, p1755 and p1609, p1612, p1619, p1620).
Note: Reference parameter for the unit system % are, for example, p2000 ... p2004. Depending on what has been
selected, these are displayed using either SI or US units.
p0528 Controller gain, system of units / Ctrl_gain unit_sys
SERVO_S110-CAN, Can be changed: C2(5)
SERVO_S110-DP,
Data type: Integer16
SERVO_S110-PN
P-Group: Applications
Not for motor type: -
Min
0
Description: Sets the system of units for the controller gains.
Value: 0:
1:
Note: For p0528 = 0 (physical/%), the following applies:
Using p0505, the dependent parameters can be changed over between physical and % representation.
For SERVO (r0107) the following applies:
The parameter is pre-assigned a value of 0 and cannot be changed.
p0530[0...n] Bearing type selection / Bearing type sel
SERVO_S110-CAN, Can be changed: C2(1, 3)
SERVO_S110-DP,
Data type: Unsigned16
SERVO_S110-PN
P-Group: Motor
Not for motor type: FEM
Min
0
Description: Sets the bearing type.
0 = No selection
1 = Manual entry
101 = STANDARD
102 = PERFORMANCE
103 = HIGH PERFORMANCE
104 = ADVANCED LIFETIME
If the bearing type changes the bearing code number (p0531) is pre-assigned accordingly.
Dependency: Refer to: p0301, p0531, p1082
1-128
SI system of units
System of units, referred/SI
US system of units
System of units, referred/US
Representation, physical/% (p0505)
Representation, no dimensions (referred)
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
4
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
1
Calculated: -
Dynamic index: MDS, p0130
Units group: -
Scaling: -
Max
104
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Access level: 1
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
1
Access level: 4
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 1
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0