Siemens SINAMICS S110 List Manual page 132

Parameter
List of parameters
Value: 1:
2:
3:
4:
5:
6:
7:
8:
9:
10:
11:
12:
13:
14:
15:
16:
17:
18:
19:
20:
21:
22:
23:
24:
25:
26:
27:
28:
29:
30:
31:
32:
Dependency: Only units of parameters with unit group 9_1 can be changed over using this parameter.
Refer to: p0596
p0596 Reference quantity, technological units / Ref tech units
SERVO_S110-CAN Can be changed: T
(Tech_ctrl),
Data type: FloatingPoint32
SERVO_S110-DP
P-Group: -
(Tech_ctrl),
Not for motor type: -
SERVO_S110-PN
(Tech_ctrl)
Min
0.01
Description: Sets the reference quantity for the technological units. When changing over using changeover parameter 595 to
absolute units, all of the parameters involved refer to the reference quantity.
Dependency: Refer to: p0595
p0600[0...n] Motor temperature sensor for monitoring / Mot temp_sensor
SERVO_S110-CAN, Can be changed: C2(3), U, T
SERVO_S110-DP,
Data type: Integer16
SERVO_S110-PN
P-Group: Motor
Not for motor type: -
Min
0
Description: Sets the sensor to monitor the motor temperature.
Value: 0:
1:
10:
11:
1-132
%
1 referred, no dimensions
bar
°C
Pa
ltr/s
m³/s
ltr/min
m³/min
ltr/h
m³/h
kg/s
kg/min
kg/h
t/min
t/h
N
kN
Nm
psi
°F
gallon/s
inch³/s
gallon/min
inch³/min
gallon/h
inch³/h
lb/s
lb/min
lb/h
lbf
lbf ft
No sensor
Temperature sensor via encoder 1
Temperature sensor via a BICO interconnection
Temperature sensor via Motor Module / CU terminals
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
340.28235E36
Calculated: CALC_MOD_ALL
Dynamic index: MDS, p0130
Units group: -
Scaling: -
Max
11
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Access level: 1
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
1.00
Access level: 2
Func. diagram: 8016
Unit selection: -
Expert list: 1
Factory setting
1