Siemens SINAMICS S110 List Manual page 204

Parameter
List of parameters
p1110[0...n] BI: Inhibit negative direction / Inhib neg dir
SERVO_S110-CAN Can be changed: T
(Extended set),
Data type: Unsigned32 / Binary
SERVO_S110-DP
P-Group: Setpoints
(Extended set),
Not for motor type: -
SERVO_S110-PN
(Extended set)
Min
-
Description: Sets the signal source to disable the negative direction.
Dependency: Refer to: p1111
p1111[0...n] BI: Inhibit positive direction / Inhib pos dir
SERVO_S110-CAN Can be changed: T
(Extended set),
Data type: Unsigned32 / Binary
SERVO_S110-DP
P-Group: Setpoints
(Extended set),
Not for motor type: -
SERVO_S110-PN
(Extended set)
Min
-
Description: Sets the signal source to disable the positive direction.
Dependency: Refer to: p1110
r1112 CO: Speed setpoint after minimum limiting / n_set n. min_lim
SERVO_S110-CAN Can be changed: -
(Extended set),
Data type: FloatingPoint32
SERVO_S110-DP
P-Group: Setpoints
(Extended set),
Not for motor type: -
SERVO_S110-PN
(Extended set)
Min
- [rpm]
Description: Displays the speed setpoint after the minimum limiting.
Dependency: Refer to: p1091, p1092, p1093, p1094, p1101
p1113[0...n] BI: Setpoint inversion / Setp inv
SERVO_S110-CAN Can be changed: T
(Extended set),
Data type: Unsigned32 / Binary
SERVO_S110-DP
(Extended set),
P-Group: Setpoints
SERVO_S110-PN
Not for motor type: -
(Extended set)
Min
-
Description: Sets the signal source to invert the setpoint.
Dependency: Refer to: r1198
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
1-204
Calculated: -
Dynamic index: CDS, p0170
Units group: -
Scaling: -
Max
-
Calculated: -
Dynamic index: CDS, p0170
Units group: -
Scaling: -
Max
-
Calculated: -
Dynamic index: -
Units group: 3_1
Scaling: p2000
Max
- [rpm]
Calculated: -
Dynamic index: CDS, p0170
Units group: -
Scaling: -
Max
-
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Access level: 3
Func. diagram: 2505, 3040
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 3
Func. diagram: 2505, 3040
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 3
Func. diagram: 3050
Unit selection: p0505
Expert list: 1
Factory setting
- [rpm]
Access level: 3
Func. diagram: 2441, 2442,
2505, 3040
Unit selection: -
Expert list: 1
Factory setting
0