Siemens SINAMICS S110 List Manual page 20

Parameter
Overview of parameters
Function diagram
The parameter is included in this function diagram. The structure of the parameter
function and its relationship with other parameters is shown in the specified func-
tion diagram.
Example:
Function diagram: 3060.3
P group (refers only to access via BOP (Basic Operator Panel))
Specifies the functional group to which the parameter belongs. The required
parameter group can be set via p0004.
Note:
Parameter p0004 is CU-specific (present on Control Unit).
"Unit", "Unit group", and "Unit selection"
The standard unit of a parameter is specified in square parentheses after the val-
ues for "Min", "Max", and "Factory setting".
For parameters where the unit can be changed, the specifications for "Unit group"
and "Unit selection" determine the group to which this parameter belongs and with
which parameter the unit can be changed over.
Example:
Unit group: 7_1, unit selection: p0505
The parameter belongs to unit group 7_1 and the unit can be changed over using
p0505.
Note:
Detailed information on changing over units can be found in the following refer-
ences:
References: /FH3/
All the potential unit groups and possible unit selections are listed below.
Table 1-3
Unit group
7_4
8_4
14_2
1-20
3060:
3:
SINAMICS S110 Function Manual Drive Functions
Unit groups (p0100)
Unit selection for p0100 =
0
Nm
N
W
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Function diagram number
Signal path (optional)
Reference variable
1
lbf ft -
lbf -
HP -
© Siemens AG 2012 All Rights Reserved
for %