Siemens SINAMICS S110 List Manual page 708

Parameter
List of parameters
p20207 DFR 1 run sequence / DFR 1 RunSeq
CU_S110-CAN, Can be changed: T
CU_S110-DP,
Data type: Unsigned16
CU_S110-PN,
P-Group: -
SERVO_S110-CAN
Not for motor type: -
(FBLOCKS),
SERVO_S110-DP
(FBLOCKS),
SERVO_S110-PN
(FBLOCKS)
Min
0
Description: Setting parameter for the run-time group of instance DFR 1 within the run-time group set in p20206.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20208[0...1] BI: BSW 0 inputs / BSW 0 inputs
CU_S110-CAN, Can be changed: T
CU_S110-DP,
Data type: Unsigned32 / Binary
CU_S110-PN,
P-Group: -
SERVO_S110-CAN
Not for motor type: -
(FBLOCKS),
SERVO_S110-DP
(FBLOCKS),
SERVO_S110-PN
(FBLOCKS)
Min
-
Description: Sets the signal source of input quantities I0 and I1 of instance BSW 0 of the binary changeover switch.
Index: [0] = Input I0
[1] = Input I1
p20209 BI: BSW 0 switch setting I / BSW 0 sw_setting
CU_S110-CAN, Can be changed: T
CU_S110-DP,
Data type: Unsigned32 / Binary
CU_S110-PN,
P-Group: -
SERVO_S110-CAN
Not for motor type: -
(FBLOCKS),
SERVO_S110-DP
(FBLOCKS),
SERVO_S110-PN
(FBLOCKS)
Min
-
Description: Sets the signal source of the switch setting I of instance BSW 0 of the binary changeover switch.
1-708
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
32000
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
-
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
-
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Access level: 1
Func. diagram: 7240
Unit selection: -
Expert list: 1
Factory setting
560
Access level: 1
Func. diagram: 7250
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 1
Func. diagram: 7250
Unit selection: -
Expert list: 1
Factory setting
0