Siemens SINAMICS S110 List Manual page 12

Parameter
Overview of parameters
1.1 Overview of parameters
1.1.1 Explanation of list of parameters
Basic structure of parameter descriptions
The data in the following example has been chosen at random. The table below
contains all the information that can be included in a parameter description. Some
of the information is optional.
The parameter list (See Chapter 1.2) is structured as follows:
- - - - - - - - - - - - - - - - - - - - Start of example- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
pxxxx[0...n] BICO: Full parameter name/Abbreviated name
Drive object (func- Can be changed: C1(x), C2(x), U, T
tion module)
Data type: Unsigned32/Integer16
P group: Control
Not for motor type: FEM
Min
0.00 [Nm]
Description: Text
Values: 0:
1:
2:
etc.
Recommenda- Text
tion:
Index: [0] = Name and meaning of index 0
[1] = Name and meaning of index 1
[2] = Name and meaning of index 2
etc.
Bit array: Bit Signal name
00 Name and meaning of bit 0
01 Name and meaning of bit 1
02 Name and meaning of bit 2
etc.
Dependency: Text
See also: pxxxx, rxxxx
See also: Fxxxxx, Axxxxx
Danger: WARNING:
Caution: Notice:
Note: Information which might be useful
- - - - - - - - - - - - - - - - - - - - End of example- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
1-12
Name and meaning of value 0
Name and meaning of value 1
Name and meaning of value 2
Caution:
Calculated: CALC_MOD_REG
Dynamic index: CDS, p0170
Unit group: 7_1
Scaling: p2000
Max
10.00 [Nm]
1 signal
Yes
Yes
Yes
Safety notices with a warning triangle
Safety notices without a warning triangle
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Access level: 2
Function diagram: 2080
Unit selection: p0505
Expert list: 1
Factory setting
0.00 [Arms]
0 signal FP
No 8010
No -
No 8012