Siemens SINAMICS S110 List Manual page 878

Reference point approach active
[3612.7] r2684.0
Flying referencing
[3614.7] r2684.1
From "referencing/flying referencing" mode [3614.4]
From interpolator [3635.7]
From interpolator [3635.7]
From interpolator [3635.3]
From interpolator [3635.7]
From dynamic following error monitoring, cam controllers
<2> From traversing range limits [3630.3]
From interpolator [3635.4]
From standstill/positioning monitoring [4020.8]
From "referencing" mode [3612.7]
From "referencing/flying referencing" mode [3614.8]
From "traversing block" mode [3616.7]
<1>
From "direct setpoint input/MDI" mode [3620.8]
From traversing range limits [3630.3]
From traversing range limits [3630.3]
From interpolator [3635.7]
<1> By default, the status bit is supplied with values from the "traversing block" mode.
However, if the "direct setpoint input/MDI" mode is active, it is supplied with values from this mode.
<2> The signal is only effective when the drive has reached the "Ready" state.
1 2
DO: SERVO
EPOS - Status word 2 (r0108.3 = 1, r0108.4 = 1)
Bit No. Status word, positioning mode 2
0 1 = Reference point approach active
1 1 = Flying referencing active
1
2 1 = Referencing active
3 1 = Print mark outside the outer window
4 1 = Axis is accelerating
5 1 = Axis is decelerating
6 1 = Jerk limiting active
7 = Activate correction
8 1 = Following error within tolerance
[4025.8]
9 1 = Modulo correction active
10 1 = Target position reached
11 1 = Reference point set
12 = Acknowledgement traversing block activated
13 1 = STOP cam minus active
14 1 = STOP cam plus active
15 1 = Traversing command active
3 4
r2684.0
r2684.1
r2684.2
r2684.3
r2684.4
r2684.5
r2684.6
r2684.7
r2684.8
r2684.9
r2684.10
r2684.11
r2684.12
r2684.13
r2684.14
r2684.15
5 6
Function diagram
fp_3646_98_eng.vsd
SINAMICS S110
07.10.08 V04.04.00
POS_ZSW2
1000.00 μs
r2684
[4010.1]/p2508
[4010.1]/p2509
[4010.3]/p2512
[3614.3] [3630.1]
[4020.1]/p2554
7 8
- 3646 -