Siemens SINAMICS S110 List Manual page 13

pxxxx[0...n] Parameter number
The parameter number is made up of a "p" or "r", followed by the parameter num-
ber and the index (optional).
Examples of number representation in the parameter list:
• p...
• r...
• p0918
• p0099[0...3]
• p1001[0...n]
• r0944
Other examples of the notation used in the documentation:
• p1070[1]
• p2098[1].3
• r0945[2](3)
• p0795.4
• r2129.0...15
The following applies to adjustable parameters:
The parameter value "when shipped" is specified under "Factory setting" with the
relevant unit in square parentheses. The value can be adjusted within the range
defined by "Min" and "Max".
The term "linked parameterization" is used in cases where changes to adjustable
parameters affect the settings of other parameters.
Linked parameterization can occur, for example, as a result of the following
actions or parameters:
• Execution of macros
p0015, p0700, p1000, p1500
• Setting PROFIBUS telegram (BICO interconnection)
p0922
• Setting component lists
p0230, p0300, p0301, p0400
• Automatic calculation and pre-assignment
p0340, p0578, p3900
• Restoring factory settings
p0970
The following applies to display parameters:
The fields "Min", "Max" and "Factory setting" are specified with a dash "-" and the
relevant unit in square parentheses.
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Adjustable parameter (read and write parameter)
Display parameters (read-only)
Adjustable parameter 918
Adjustable parameter 99, indices 0 to 3
Adjustable parameter 1001, indices 0 to n (n = configurable)
Display parameter 944
Adjustable parameter 1070, index 1
Adjustable parameter 2098, index 1 bit 3
Display parameter 945, index 2 of drive object 3
Adjustable parameter 795, bit 4
Display parameter 2129 with bit array (maximum 16 bits)
Parameter
Overview of parameters
1-13