Display Time-Range - H3C s3100 series Command Manual

port-group group-id: Displays information about packet filtering on the port group specified by group-id.
unitid unit-id: Displays information about packet filtering on the unit specified by unit-id. The unit ID can
be set only to 1.
vlan vlan-id: Displays information about packet filtering on the VLAN specified by vlan-id.
Description
Use the display packet-filter command to display information about packet filtering.
Only H3C S3100-EI series switches support this command.
Example
# Display information about packet filtering on the switch.
<Sysname> display packet-filter unitid 1
Ethernet1/0/1
Inbound:
Acl 2000 rule 0
Table 1-3 Description on the fields of the display packet-filter command
Field
Ethernet1/0/1
Inbound
Acl 2000 rule 0
running

display time-range

Syntax
display time-range { all | time-name }
View
Any view
Parameters
all: Displays all time ranges.
time-name: Name of a time range, a string of 1 to 32 characters that starts with a to z or A to Z.
running
Packet filtering is performed on Ethernet1/0/1.
Packet filtering is performed in the inbound direction.
The rule 0 of ACL 2000 is used.
Status of the rule, which can be
running: The ACL rule is active.
not running: The ACL rule is inactive. Usually, this is because the
current time is out of the rule's time range.
Description
1-6