Ip Vrrp Accept-Data - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

Chapter 10: I Commands

ip vrrp accept-data

[ no ] ip vrrp vrid accept-data
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Enables the backup router to process packets with an IP destination address equivalent
Description
to the virtual addresses while the backup router is in the master state. The no version
restores the default value, disabled.
NOTE: When using this attribute and also restricting incoming packets to ICMP only,
you must use policy filters to accept only ICMP packets with the virtual address as
the destination address.
vrid VRID identifier; a number in the range 1–255
Options
Interface Configuration
Mode
955
ip vrrp accept-data