Renesas RL78/G1P Hardware User Manual page 713

RL78/G1P
25.1 BCD Correction Circuit Function
The result of addition/subtraction of the BCD (binary-coded decimal) code and BCD code can be obtained as BCD
code with this circuit.
The decimal correction operation result is obtained by performing addition/subtraction having the A register as the
operand and then adding/subtracting the BCD correction result register (BCDADJ).
25.2 Registers Used by BCD Correction Circuit
The BCD correction circuit uses the following registers.
 BCD correction result register (BCDADJ)
25.2.1 BCD correction result register (BCDADJ)
The BCDADJ register stores correction values for obtaining the add/subtract result as BCD code through add/subtract
instructions using the A register as the operand.
The value read from the BCDADJ register varies depending on the value of the A register when it is read and those of
the CY and AC flags.
The BCDADJ register is read by an 8-bit memory manipulation instruction.
Reset input sets this register to undefined.
Address: F00FEH After reset: Undefined
Symbol 7
BCDADJ
R01UH0895EJ0100 Rev.1.00
Nov 29, 2019
CHAPTER 25 BCD CORRECTION CIRCUIT
Figure 25-1. Format of BCD Correction Result Register (BCDADJ)
R
6 5
CHAPTER 25 BCD CORRECTION CIRCUIT
4 3 2 1 0
694