Renesas RL78/G1P Hardware User Manual page 362

RL78/G1P
(2) Operation procedure
Setting the PER0 register
Setting the SPSm register
Setting the SMRmn register
Setting the SCRmn register
Setting the SDRmn register
Setting of the SOEm register
Writing to the SSm register
R01UH0895EJ0100 Rev.1.00
Nov 29, 2019
Figure 11-25. Initial Setting Procedure for Master Transmission
Starting initial setting
Setting the SOm register
Setting port
Completing initial setting
CHAPTER 11 SERIAL ARRAY UNIT
Release the serial array unit from the
reset status and start clock supply.
Set the operation clock.
Set an operation mode, etc.
Set a communication format.
Set a transfer baud rate (setting the
transfer clock by dividing the operation
clock (f )).
MCK
Set the initial output level of the serial
clock (CKOmn) and serial data (SOmn).
Set the SOEmn bit to 1 and enable data
output of the target channel.
Setting a port register and a port mode
register (Enable data output and clock
output of the target channel by)
Set the SSmn bit of the target channel to 1
(SEmn bit = 1: to enable operation).
Setting of SAU is completed.
Write transmit data to the SIOp register
(bits 7 to 0 of the SDRmn register) and
start communication.
343