Renesas RL78/G1P Hardware User Manual page 709

RL78/G1P
23.8 Processing Time for Each Command When PG-FP6 Is in Use (Reference Value)
The following shows the processing time for each command (reference value) when PG-FP6 is used as a dedicated flash
memory programmer.
Table 23-15. Processing Time for Each Command When PG-FP6 Is in Use (Reference Value)
PG-FP6 Command
Erasing
Writing 1
Verification
Writing after erasing
Remark The command processing times (reference values) shown in the table are typical values under the following
conditions.
Port:
Speed:
Mode:
R01UH0895EJ0100 Rev.1.00
Nov 29, 2019
Port: TOOL0 (UART)
Speed: 1 Mbps
16 Kbytes
0.7 s
0.8 s
0.6 s
1.2 s
TOOL0 (single-line UART)
1,000,000 bps
Full speed mode (flash operation mode: HS (high speed main) mode).
CHAPTER 23 FLASH MEMORY
690