Outline Of Functions - Renesas RL78/G1P Hardware User Manual

RL78/G1P

1.6 Outline of Functions

Item
Code flash memory
Data flash memory
RAM
Memory space
Main system High-speed
clock system clock
High-speed on-
chip oscillator
clock (f
IH
Low-speed on-chip oscillator clock
General-purpose registers
Minimum instruction execution time
Instruction set
I/O port Total
CMOS I/O
CMOS input
N-ch O.D I/O
(6 V tolerance)
Timer 16-bit timer
Watchdog timer
Timer output
Clock output/buzzer output
8/12-bit resolution A/D converter
10-bit D/A converter
Serial interface
2
I C bus
DMA controller
Event link controller (ELC)
Vectored Internal
interrupt sources
External
Note This is about 0.5 KB when the self-programming function and data flash function are used. For details, see
CHAPTER 3.
R01UH0895EJ0100 Rev.1.00
Nov 29, 2019
R5F11Z7AANA, R5F11Z7ADNA
16 KB
2 KB
Note
1.5 KB
1 MB
X1 (crystal/ceramic) oscillation, external main system clock input (EXCLK)
1 to 20 MHz: V
DD
High-speed operation: 32 MHz (V
)
15 kHz (TYP.): V
DD
8 bits  32 registers (8 bits  8 registers  4 banks)

0.03125 s (High-speed on-chip oscillator: f

0.05 s (High-speed system clock: f
 Data transfer (8/16 bits)
 Adder and subtractor/logical operation (8/16 bits)
 Multiplication (8 bits  8 bits)
 Rotate, barrel shift, and bit manipulation (set, reset, test, and boolean operation), etc.
20
15
3
2
4 channels (TAU)
1 channel
4
PWM outputs: 3
2
 2.44 kHz, 4.88 kHz, 9.77 kHz, 1.25 MHz, 2.5 MHz, 5 MHz, 10 MHz
(Main system clock: f
6 channels
2 channels
 CSI: 1 channel/UART: 1 channel
1 channel (2 slave addresses)
2 channels
Event input: 10, Event trigger output: 3
12
6
24-pin
= 2.7 to 3.6 V
= 2.7 to 3.6 V)
DD
= 2.7 to 3.6 V
= 32 MHz operation)
IH
= 20 MHz operation)
MX
= 20 MHz operation)
MAIN
CHAPTER 1 OUTLINE
32-pin
R5F11ZBAAFP, R5F11ZBADFP
28
23
3
2
8 channels
(1/2)
9