Encapsulation - Avaya G450 Cli Reference Manual

CLI Commands
Parameter
channel_group
sub_interface
ip_interface
if_link_type
User Level
read-write
Context
general, interface:Serial (FR SUB)
Example
To create point to point sub-interface number 17 over channel group 2 over E1/T1 controller
number 1:
G450-001(super)# interface Serial 3/1:2.17 point-to-point
Related Commands
description (interface),
tunnel, interface
ip crypto-group, load-interval,

encapsulation

Use the encapsulation command to set the encapsulation mode for a Serial interface. By
default, the Serial interface has PPP encapsulation. Use the no form of this command, which
has no parameters, to return to the default.
Use the encapsulation frame-relay option to create a frame-relay interface of the
IETF (RFC1490/RFC2427) type or non-IETF type. This command deletes the PPP interface
associated with the current Serial interface. The PPP interface cannot be deleted if at least one
IP interface is defined on it. Instead, the following message appears, "You cannot update this L2
interface since L3 interfaces are defined on it."
By default, the Frame Relay encapsulation type for the main interface is IETF.
Note:
Non-IETF encapsulation is compatible with other vendors.
Note:
810 Avaya G450 CLI Reference
Description
interface console,
USB-modem, interface
show ip interface brief
interface fastethernet,
vlan, ip address, ip admin-state,
PPP encapsulation
Possible Default
Values Value
For E1: 0-30
For T1: 0-23
1-127
0-1024
point-to-point
interface loopback, interface
ip broadcast-address,