Ip Crypto-Group - Avaya G450 Cli Reference Manual

ip crypto-group

Use the ip crypto-group command to activate a crypto-list in the context of the interface on
which the crypto-list is activated. The command applies to the following interfaces:
Serial
●
FastEthernet
●
Dialer
●
Use the no form of the command to deactivate a crypto-list.
Note:
The ip crypto-group command applies also to the VLAN interface, but this
Note:
option is not recommended.
Note:
Most IPSec VPN parameters cannot be modified if they are linked to an active
Note:
crypto-list. To modify a parameter linked to an active crypto-list, you must first
deactivate the list using the no ip crypto-group command in the context of
the interface on which the crypto-list is activated.
Syntax
[no] ip crypto-group crypto-list-id
Parameters
Parameter
crypto_list_id
User Level
read-write
Context
interface:Serial (DS1 FR-SUB L2, DS1 FR-SUB L2-L3, DS1 PPP L2, DS1 PPP L2-L3, USP
PPP L2, USP PPP L2-L3), FastEthernet (L2, L2-L3, PPP L2, PPP L2-L3, PPP L3), Dialer (L2,
L2-L3), VLAN (L2, L2-L3)
Example
To activate crypto-list 901:
G450-001(if:Serial 4/1)# ip crypto-group 901
Description
The crypto-list number
Possible Default
Values Value
901-999
Issue 1 January 2008
VPN
1241