Bandwidth - Avaya G450 Cli Reference Manual

Example
To create point to point sub-interface number 17 over channel group 2 over E1/T1 controller
number 1:
G450-001(super)# interface Serial 3/1:2.17 point-to-point
Related Commands
description (interface),
tunnel, interface
ip crypto-group, load-interval,

bandwidth

Use the bandwidth command to set the bandwidth parameter manually for this interface. Use
the no form of this command to restore the bandwidth parameter to its default value. The
manually specified bandwidth value overrides the dynamically calculated bandwidth during
route cost calculations.
Syntax
bandwidth kilobits
no bandwidth
Parameters
Parameter
kilobits
User Level
read-write
Context
interface:Serial (DS1 PPP L2, DS1 PPP L2-L3, DS1 FR L2, DS1 FR-SUB L2,
DS1 FR-SUB L2-L3, USP PPP L2, USP PPP L2-L3, USP FR L2), FastEthernet (L2, L2-L3, PPP
L2, PPP L2-L3), VLAN (L2, L2-L3), Loopback (L2, L2-L3), Tunnel (L2, L2-L3), Dialer (L2, L2-L3)
interface console,
USB-modem, interface
show ip interface brief
Description
The bandwidth for the interface in kilobits
per second
interface fastethernet,
vlan, ip address, ip admin-state,
USP configuration
interface loopback, interface
ip broadcast-address,
Possible Default
Values Value
1-10000000 2048
(for
Frame
Relay)
Issue 1 January 2008 1169