Wait-Interval - Avaya G450 Cli Reference Manual

wait-interval

Use the wait-interval command to specify how long an RTR operation should wait for a
device to answer an RTR probe. When the wait-interval is exceeded, the probe is considered an
unanswered probe.
Use the no form of this command to restore the value to the default.
Note:
You must run the type command to define the RTR operation's probing method
Note:
and the IP address of the remote device before you can use the
wait-interval command.
Note:
The value of wait-interval cannot be greater than the value of frequency.
Note:
Syntax
[no] wait-interval wait-value [seconds | milliseconds]
Parameters
Parameter
wait-value
seconds
milliseconds
User Level
read-write
Context
rtr, rtr type
Description
A number indicating how
long to wait for a response
to the probe before
considering it an
unanswered probe
Keyword indicating to set
the wait interval in units of
seconds
Keyword indicating to set
the wait interval in units of
milliseconds
Possible Values
1-60 seconds
or
200-60,000 milliseconds
Issue 1 January 2008
Object tracking
Default Value
Same as
default value
of
frequency
603