Ip-Protocol - Avaya G450 Cli Reference Manual

ip-protocol

Use the ip-protocol command to specify that the current rule applies to packets having the
specified IP protocol.
Use the no form of the command to set the IP protocol to its default value.
Use the not form of this command to specify that the current rule applies to all packets except
those having the specified IP protocol.
Syntax
[not] ip-protocol protocol_name | protocol_number
no ip-protocol
Parameters
Parameter
protocol_name
protocol_number
User Level
read-write
Context
ip access-control-list/ip-rule, ip capture-list/ip-rule, ip pbr-list/ip-rule, ip qos-list/ip-rule,
crypto-list/ip-rule
Note:
The not form of the command is not relevant in the crypto-list/ip-rule context.
Note:
Example
To specify that rule 22 applies to all packets having an IP protocol of ICMP:
G450-001(ACL 330/ip rule 22)# ip-protocol icmp
To specify that rule 22 applies to all packets having any IP protocol except ICMP:
G450-001(ACL 330/ip rule 22)# not ip-protocol icmp
Related Commands - Packet sniffing
destination-ip, dscp (policy-based routing, packet sniffing,
source-ip, tcp destination-port,
Description
Name of the IP protocol to match
Number of the IP protocol to match
tcp source-port,
VPN), icmp,
udp destination-port, udp source-port
Policy - access control lists
Possible Default
Values Value
1-255
show ip capture-list,
Issue 1 January 2008 691