Encapsulation Pppoe - Avaya G450 Cli Reference Manual

Parameters
Parameter
module
port
ip_interface
User Level
read-write
Context
general
Example
To create a FastEthernet interface and enter its context:
G450-001(super)# interface FastEthernet 10/2
To create a Level 3 sub-interface on the FastEthernet interface:
G450-001(super)# interface FastEthernet 10/2.1
Related Commands
description (interface),
interface USB-modem,
crypto-group, load-interval,

encapsulation pppoe

Use the encapsulation pppoe command to enable the PPPoE client. Use the no form of
the command to return to disable the PPPoE client.
Note:
The encapsulation pppoe command fails if:
Note:
- ip address is configured on the interface
- The interface is part of a backup scheme
- Dynamic CAC is configured on the interface
Description
The module number of the interface
The port number of the interface
The IP sub-interface number within this
interface. A number of IP interfaces may
be bound to a Layer 3 interface.
interface console, interface
interface vlan, ip address,
show ip interface brief
PPPoE (PPP over Ethernet)
Possible
Values
10
3
0-1024
loopback, interface serial,
ip admin-state, ip broadcast-address,
Issue 1 January 2008
Default
Value
interface tunnel,
ip
819