Dialer Persistent Initial Delay - Avaya G450 Cli Reference Manual

CLI Commands
User Level
read-write
Context
interface:Dialer (L2, L2-L3)
Example
To set the redial interval to 20 seconds:
G450-001(if:Dialer 1)# dialer persistent delay 20
Related Commands
interface dialer,
delay, dialer persistent
wait-for-ipcp

dialer persistent initial delay

Use the dialer persistent initial delay command to set the minimum delay from
boot to persistent dialing. Use the no form of the command to return the delay to the default
value.
Note:
Use this command to prevent the Dialer interface from dialing out after the G450
Note:
is reset. This is needed because the primary interface does not become active
immediately after the reset.
Syntax
[no] dialer persistent initial delay sec
Parameters
Parameter
sec
User Level
read-write
Context
interface:Dialer (L2, L2-L3)
328 Avaya G450 CLI Reference
dialer modem-interface,
max-attempts,
Description
Initial delay
dialer order, dialer persistent,
dialer persistent re-enable,
Dialer interface
dialer persistent initial
dialer string, dialer
Possible Default
Values Value
1-1000 1