Source-Ip - Avaya G450 Cli Reference Manual

CLI Commands
Related Commands - DoS
DoS-classification,

source-ip

Use the source-ip command to indicate that the current rule applies to packets from the
specified source IP address.
Use the no form of the command to indicate that the current rule applies to packets from any IP
address.
Use the not form of the command to indicate that the current rule applies to all packets except
those coming from the specified IP address.
Syntax
[not] source-ip {host ip_address | any | ip_address wildcard}
no source-ip
Parameters
Parameter
host
ip_address
any
ip_address
wildcard
User Level
read-write
Context
ip pbr-list ip-rule, ip qos-list ip-rule, ip capture-list ip-rule, ip access-control-list ip-rule, ip
crypto-list ip-rule
660 Avaya G450 CLI Reference
show ip access-control-list
Description
Keyword that indicates a specific host IP
address
The IP address of the host
Keyword that indicates any IP address
The range of IP addresses of the rule.
The zero bits in the wildcard correspond to
bits in the IP address that remain fixed. The
one bits in the wildcard correspond to bits in
the IP address that can vary. Note: This is
the opposite of how bits are used in a
netmask.
Packet sniffing
Possible Default
Values Value