Avaya G450 Cli Reference Manual page 772

CLI Commands
Syntax
[not] destination-ip {host ip}|any|{ip wildcard}
no destination-ip
Parameters
Parameter
host
ip
any
ip
wildcard
User Level
read-write
Context
ip capture-list/ip-rule, ip access-control-list/ip-rule, ip pbr-list/ip-rule, ip qos-list/ip-rule, ip
crypto-list ip-rule
Example
To specify that rule 22 applies to all packets having destination IP address 135.64.104.102:
G450-001(QoS 460/rule 22)# destination-ip host 135.64.104.102
To specify that rule 17 applies to packets whose destination IP address is not in the range of
176.13.0.0 through 176.13.255.255:
G450-001(QoS 460/rule 17)# not destination-ip 176.13.0.0 0.0.255.255
Related Commands - Packet sniffing
dscp (policy-based routing, packet sniffing,
source-ip, tcp
772 Avaya G450 CLI Reference
Description
Keyword that specifies the current rule
applies to a single host IP address
The destination IP address of the rule
Keyword that specifies the current rule
applies to any address
The range of IP addresses of the rule.
The zero bits in the wildcard correspond to
bits in the IP address that remain fixed. The
one bits in the wildcard correspond to bits in
the IP address that can vary.
Note: This is the opposite of how bits are
used in a netmask.
destination-port, tcp source-port,
VPN), icmp, ip-protocol,
udp destination-port,
Policy-based routing
Possible Default
Values Value
show ip capture-list,
udp source-port