Ip Admin-State - Avaya G450 Cli Reference Manual

Related Commands
description (interface),
serial, interface
broadcast-address, load-interval,

ip admin-state

Use the ip admin-state command to set the administrative state of an IP interface. The
default state is up.
Syntax
ip admin-state up|down
Parameters
Parameter
up
down
User Level
read-write
Context
interface:Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3), VLAN (L2-L3, L3), Loopback (L2-L3,
L3), Tunnel (L2-L3, L3), Dialer (L2-L3, L3, PPP L2-L3, PPP L3)
Example
To set the administrative state of an IP interface to up:
G450-001(super-if:FastEthernet 10/2)# ip admin-state up
Related Commands
description (interface),
serial, interface
load-interval, show ip interface brief
interface console,
tunnel, interface USB-modem,
show ip interface brief
Description
Keyword specifying the administrative state
of the IP interface is set to up (active)
Keyword specifying the administrative state
of the IP interface is set to down (inactive)
interface console,
tunnel, interface USB-modem,
interface fastethernet,
interface vlan, ip
interface fastethernet,
interface vlan, ip
IP interface configuration
interface loopback, interface
admin-state, ip
Possible Default
Values Value
interface loopback, interface
address, ip broadcast-address,
Issue 1 January 2008 473