Show Controllers - Avaya G450 Cli Reference Manual

CLI Commands
Example
To assign the IP address 192.168.22.33 with mask 255.255.255.0 to the FastEthernet interface:
G450-001(if:FastEthernet 10/2)# ip address 192.168.22.33 255.255.255.0
Related Commands
clear controller
source, ds-mode, fdl, framing,
show controllers,

show controllers

Use the show controllers command to display status information about a controller
interface.
Syntax
show controllers [module/port]
Parameters
Parameter
module
port
User Level
read-write
Context
general
Example
To display controller status information:
G450-001(super)# show controllers
T1 5/1 is down.
Cablelength is long gain26 0db.
Transmitter is sending remote alarm.
Receiver has loss of signal.
Framing is SF, Line Code is AMI, Clock Source is Line.
372 Avaya G450 CLI Reference
counters, controller, cablelength
interface
show controllers remote,
Description
The module number
The port number
long, cablelength
serial, linecode (E1), linecode
show ds-mode
E1/T1 interfaces
short, channel-group,
(T1), loopback, remote,
Possible Default
Values Value
clock