Set Trunk-Group-Chan-Select - Avaya G450 Cli Reference Manual

set trunk-group-chan-select

Use the set trunk-group-chan-select command to specify the trunk-group number that
can accept incoming calls in cases where the Information Channel Selection field does not
specify a preferred channel for bearer transport in SLS.
Syntax
set trunk-group-chan-select tgnum
Parameters
Parameter
tgnum
User Level
read-write
Context
sls > sig-group
Example
To specify that trunk-group 99 can accept incoming calls:
●
G450-001(sls-sig-group 100)# set trunk-group-chan-select 99
To clear any previously set value for trunk-group selection:
●
G450-001(sls-sig-group 100)# set trunk-group-chan-select 0
Related Commands
add nfas-interface,
primary-dchannel,
Description
Trunk group number.
Note: Use the 0 value to clear any
previously set tgnum value.
clear sig-group, remove
set sls, show (sig-group),
Possible
Values
0
1-2000
nfas-interface, set associated-signaling,
show sig-group, show
SLS survivability
Default
Value
set
sls, sig-group, sls
Issue 1 January 2008 1017