Ip Redirects; Ip Route - Avaya G450 Cli Reference Manual

CLI Commands
Related Commands
clear ip route,
best-match, show ip route

ip redirects

Use the ip redirects command to enable the sending of redirect messages on the current
interface. Use the no form of this command to disable redirect messages. By default, sending of
redirect messages on the interface is enabled.
Syntax
[no] ip redirects
User Level
read-write
Context
interface:Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3, PPP L2, PPP L2-L3, PPP L3),
Tunnel (L2-L3, L3), VLAN (L2-L3, L3), Dialer (L2, L2-L3, L3)
Related Commands
clear ip route,
route best-match,
traceroute

ip route

Use the ip route command to establish a static route. Use the no form of this command to
remove a static route.
Syntax
ip route ip_addr mask {{next_hop [next_hop [next_hop]] } |
{interface_type interface_number}} [cost] [preference] [permanent |
{track track-index} | Null0]
Note:
You may specify up to three next hops. However, if you apply tracking, you may
Note:
only specify one next hop.
886 Avaya G450 CLI Reference
ip default-gateway, ip
static, show ip route
ip default-gateway, ip
show ip route static,
redirects, ip route, ip routing,
summary,
netmask-format, ip route,
show ip route summary,
Routing table configuration
show ip route,
show ip route track-table,
ip routing, show ip
show ip route track-table,
show ip route
traceroute
route, show ip