Ip Ospf Network Point-To-Multipoint; Ip Ospf Priority - Avaya G450 Cli Reference Manual

CLI Commands

ip ospf network point-to-multipoint

Use the ip ospf network point-to-multipoint command to specify the network type
as point-to-multipoint for the interface, and to increase the OSPF timers appropriately. Use the
no form of the command to return the interface to point-to-point topology.
Syntax
[no] ip ospf network point-to-multipoint
User Level
read-write
Context
interface:Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3, PPP L2-L3, PPP L3), VLAN (L2-L3,
L3), Loopback (L2-L3, L3), Tunnel (L2-L3, L3), Dialer (L2-L3, L3)
Example
To specify a network type of point-to-multipoint for the VLAN 1 interface:
G450-001(if:Vlan 1)# ip ospf network point-to-multipoint
Related Commands
ip ospf authentication,
hello-interval, ip ospf
ospf, show ip ospf

ip ospf priority

Use the ip ospf priority command to configure interface priority, which is used during the
election of a designated router. Use the no form of this command to set the OSPF priority to its
default value.
Syntax
ip ospf priority priority
no ip ospf priority
622 Avaya G450 CLI Reference
ip ospf authentication-key,
message-digest-key,
database, show ip ospf
ip ospf cost, ip ospf
ip ospf priority, ip ospf
interface, show ip ospf
dead-interval, ip ospf
router-id, router ospf,
neighbor, show ip protocols
OSPF
show ip