Avaya G450 Cli Reference Manual page 702

CLI Commands
Parameter
start_port
end_port
User Level
read-write
Context
ip pbr-list ip-rule, ip qos-list ip-rule, ip capture-list ip-rule, ip access-control-list ip-rule, ip
crypto-list ip-rule
Note:
The not form of the command is not relevant in the crypto-list ip-rule context.
Note:
Example
To specify that rule 22 applies to all packets whose destination port is port 300:
G450-001(ACL 330/ip rule 22)# udp destination-port eq 300
To specify that rule 22 applies to all packets except for those whose destination port is 300:
G450-001(ACL 330/ip rule 22)# not udp destination-port eq 300
Related Commands - Policy-based routing
destination-ip,
capture-list, source-ip,
Related Commands - Policy
composite-operation, destination-ip,
dscp-table, show isdn bri
udp source-port
Related Commands - VPN
description (ip
icmp, ip crypto-list, ip-protocol,
show ip crypto-list,
702 Avaya G450 CLI Reference
Description
The start of a port range for which to apply the
rule
The end of a port range for which to apply the
rule
dscp (policy-based routing, packet sniffing,
tcp destination-port,
link, source-ip,
rule), destination-ip, dscp (policy-based routing, packet sniffing,
ip-rule
tcp destination-port,
tcp source-port,
dscp (policy), icmp, show
tcp destination-port,
(VPN), local-address,
tcp source-port, udp source-port
Policy - access control lists
Possible
Values
VPN), icmp, ip-protocol,
udp source-port
composite-operation,
tcp established, tcp
VPN), fragment,
protect crypto map, source-ip,
Default
Value
show ip
show
source-port,