Fragment - Avaya G450 Cli Reference Manual

CLI Commands
Context
ip capture-list ip-rule, ip pbr-list ip-rule, ip access-control-list ip-rule, ip qos-list ip-rule, ip
crypto-list ip-rule
Note:
In ip-rule context, this command tests packets to see if they match the specified
Note:
DSCP value, but does not change the DSCP value.
Note:
The not form of the command is not relevant in the crypto-list ip-rule context.
Note:
Example
To specify that ip-rule 10 in crypto-list 901 match a DSCP value of 43:
G450-001(Crypto 901/ip rule 10)# dscp 43
To specify that ip-rule 10 in crypto-list 901 match any DSCP value:
G450-001(Crypto 901/ip rule 10)# no dscp
Related Commands - Packet sniffing
destination-ip, icmp, ip-protocol,
source-port, udp
Related Commands - Policy-based routing
destination-ip,
Related Commands - VPN
description (ip
local-address,
source-port, udp

fragment

Use the fragment command to apply the current rule for non-initial fragments only.
Note:
You cannot specify TCP/UDP ports or ICMP code/type for a rule when using the
Note:
fragment command.
Syntax
fragment
654 Avaya G450 CLI Reference
show ip
destination-port, udp source-port
next-hop (policy-based
rule), destination-ip, fragment, icmp,
protect crypto map, source-ip,
destination-port, udp source-port
capture-list, source-ip,
routing), show ip next-hop-list,
ip crypto-list, ip-protocol,
show ip crypto-list,
Packet sniffing
tcp destination-port, tcp
show isdn bri link
ip-rule (VPN),
tcp destination-port, tcp