Set Layer1-Stable - Avaya G450 Cli Reference Manual

Example
To set the interface to agree with A-law companding for DS1:
G450-001 (sls-ds1-<port address>)# set interface-companding alaw
to set the interface to agree with A-law companding for BRI:
G450-001 (sls-bri-<port address>)# set interface-companding alaw
Related DS1 commands
clear ds1, set bearer-capability,
country-protocol,
signaling-mode,
Related BRI commands
bri, clear bri, set
directory-number-b,
spid-a, set spid-b,

set layer1-stable

Use the set layer1-stable command to determine whether or not to keep the physical
layer active (stable) between calls in SLS. Some European countries, France, for example,
require that the physical layer is deactivated when there is no active call.
Note:
This command is valid only for a BRI circuit employed with ISDN.
Note:
Syntax
set layer1-stable {yes | no}
Parameters
Parameter
yes
no
set bit-rate,
set interface, set long-timer,
set sls, show (ds1), show
bearer-capability, set
set endpoint-init, set
set sls, set tei-assignment,
Description
Keyword specifying to keep the
physical layer active between calls.
This is the default.
Keyword specifying not to keep the
physical layer active between calls
set channel-numbering,
set name, set
ds1, show sls, sls
country-protocol, set directory-number-a,
interface, set layer1-stable,
show bri, show
SLS survivability
set connect, set
protocol-version, set side,
set
set name, set
(bri), show sls, sls
Possible Default
Values Value
Issue 1 January 2008
set
side, set
933