Snmp-Server User - Avaya G450 Cli Reference Manual

User Level
admin
Context
general
Example
To create or configure a remote SNMPv3 user, with username john, associated with group
L2Group, and accessing engine
G450-001(super)# snmp-server remote-user john
L2Group
Related Commands - SNMP access configuration
ip snmp, set snmp
engineID, show snmp
snmp usertogroup,
snmp-server group,
Related Commands - SNMP trap configuration
set port trap, set snmp trap enable | disable
show port trap,
snmp-server host,
Related Commands - Dynamic trap manager
snmp-server dynamic-trap-manager

snmp-server user

Use the snmp-server user command to configure settings for an SNMPv3 user. If the user
does not exist, it is created. Use the no form of the command to remove the user from specific
groups. If no groups are specified, the user is removed from all groups.
Syntax
snmp-server user username groupname {{v1|v2c}|{v3 [auth {md5|sha}
auth-password [priv des56 priv-password]]}}
no snmp-server user username [groupname {v1|v2c|v3}]]
00:02:00:81:00:d0:00:4c:18:00
community, set snmp
group, show snmp
show snmp view,
snmp-server user,
show snmp, snmp trap
snmp-server informs
00:02:00:81:00:d0:00:4c:18:00
retries, set snmp timeout,
retries, show snmp
snmp-server community,
snmp-server view
auth, set snmp trap enable | disable
link-status, snmp-server enable
SNMP access configuration
:
show snmp, show snmp
timeout, show snmp user,
snmp-server engineID,
frame-relay,
notifications,
Issue 1 January 2008
show
1083