Show Port Flowcontrol - Avaya G450 Cli Reference Manual

CLI Commands
Parameters
Parameter
module
port
User Level
read-only
Context
general
Example
To show edge state for all ports:
G450-001(super)# show port edge state
Related Commands
set port auto-negotiation-flowcontrol-advertisement,
set port edge admin
name, set port
auto-negotiation-flowcontrol-advertisement,

show port flowcontrol

Use the show port flowcontrol command to display port flow control information. If no
port is specified, information for all ports is displayed.
Syntax
show port flowcontrol [module[/port]]
388 Avaya G450 CLI Reference
Description
Number of the module
Number of the port on the module.
You can also specify a range of ports
separated by a dash, for example, 10/5-6 for
both ETH LAN ports 5-6 on the front panel.
state, set port enable |
negotiation, set port point-to-point admin
set port enable |
disable, set port flowcontrol,
status, set port
show port flowcontrol
Ethernet port configuration
Possible Default
Values Value
disable, set port duplex,
set port level, set port
speed, show port