Keepalive-Track - Avaya G450 Cli Reference Manual

CLI Commands
Parameter
on-demand
periodic
User Level
read-write
Context
crypto isakmp peer
Example
To enable DPD keepalives, setting the rate to 10 seconds and retries to 2:
G450-001(config-peer:149.49.70.1)# keepalive 10 retry 2
Related Commands
description (ISAKMP
mode, isakmp-policy, keepalive-track, pre-shared-key, self-identity,
crypto isakmp

keepalive-track

Use the keepalive-track command to bind an object tracker to a remote VPN peer or to an
interface, to check whether the remote peer or the interface is up. Use the no form of this
command to disable this mechanism (default setting).
Note:
When configuring VPN, you can use the keepalive-track command instead
Note:
of the keepalive command when the remote peer does not support DPD, or
when you want to monitor servers behind the VPN remote peer.
Note:
You cannot configure both keepalive-track and ip address dhcp (DHCP
Note:
Client) on the WAN FastEthernet interface.
Syntax
keepalive-track track-id
1220 Avaya G450 CLI Reference
Description
Keyword indicating to send DPD probes
only when data traffic is sent to the remote
peer
Keyword indicating to send DPD probes
periodically, regardless of whether data
traffic is being sent to the remote peer
peer), continuous-channel,
peer, suggest-key
Possible
Values
crypto isakmp peer,
VPN
Default
Value
initiate
show