Source-Ip - Avaya G450 Cli Reference Manual

source-ip

Use the source-ip command to indicate that the current rule applies to packets from the
specified source IP address.
Use the no form of the command to indicate that the current rule applies to packets from any IP
address.
Use the not form of the command to indicate that the current rule applies to all packets except
those coming from the specified IP address.
Syntax
[not] source-ip {host ip_address | any | ip_address wildcard}
no source-ip
Parameters
Parameter
host
ip_address
any
ip_address
wildcard
User Level
read-write
Context
ip pbr-list ip-rule, ip qos-list ip-rule, ip capture-list ip-rule, ip access-control-list ip-rule, ip
crypto-list ip-rule
Note:
The not form of the command is not relevant in the crypto-list ip-rule context.
Note:
Description
Keyword that indicates a specific host IP
address
The IP address of packets to which the rule
is applied
Keyword that indicates any IP address
The range of IP addresses of the rule.
The zero bits in the wildcard correspond to
bits in the IP address that remain fixed. The
one bits in the wildcard correspond to bits in
the IP address that can vary.
Note: This is the opposite of how bits are
used in a netmask.
Policy - access control lists
Possible Default
Values Value
Issue 1 January 2008 695