Set Lldp Tx-Hold-Multiplier - Avaya G450 Cli Reference Manual

This transmission rate limiting applies only to situations caused by asynchronous transmission
or shutdown when the LLDP application is stopped on a port or system in an Avaya device.
Syntax
set lldp tx-delay value
Parameters
Parameter
value
User Level
read-write
Context
general
Example
To set the TxDelay to 5 seconds:
G450-001(super)# set lldp tx-delay 5
Related Commands
set lldp re-init-delay,
port lldp, set port lldp
vlan-name config

set lldp tx-hold-multiplier

Use the set lldp tx-hold-multiplier command to set the multiplier on the interval that
determines the actual TTL value sent in an LLDP frame. The time-to-live value transmitted in
TTL TLV by the device is expressed by the following formula:
TTL = min(65535, TxInterval * TxHoldMultiplier)
Syntax:
set lldp tx-hold-multiplier number
Description
Minimum delay in seconds between successive
LLDP frame transmissions
set lldp system-control,
tlv, show lldp, show lldp
set lldp tx-hold-multiplier,
config, show port lldp
Possible Default
Values Value
1-8,192 30
set lldp tx-interval, set
config, show port lldp
Issue 1 January 2008
LLDP
533