Ip Ospf Dead-Interval - Avaya G450 Cli Reference Manual

ip ospf dead-interval

Use the ip ospf dead-interval command to configure the interval before declaring the
neighbor as dead. Use the no form of this command to set the dead-interval to its default value.
Syntax
ip ospf dead-interval seconds
no ip ospf dead-interval
Parameters
Parameter
seconds
User Level
read-write
Context
interface:Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3, PPP L2-L3, PPP L3), VLAN (L2-L3,
L3), Loopback (L2-L3, L3), Tunnel (L2-L3, L3), Dialer (L2-L3, L3)
Example
To specify an interval of 15 seconds to wait before declaring a neighbor dead:
G450-001(if:Vlan 1)# ip ospf dead-interval 15
Related Commands
ip ospf authentication,
message-digest-key,
ospf, show ip ospf,
ip protocols
Description
The interval in seconds
ip ospf authentication-key,
ip ospf network point-to-multipoint,
show ip ospf database,
ip ospf cost, ip ospf
ip ospf priority,
show ip ospf interface,
Possible Default
Values Value
1-415029 40
hello-interval, ip ospf
ip ospf router-id,
show ip ospf neighbor,
Issue 1 January 2008
OSPF
router
show
619