Etr; Set Etr - Avaya G450 Cli Reference Manual

CLI Commands
Field
Send-
Flowcontrol-Oper
Receive-Flowcontrol-
Admin
Receive-Flowcontrol-
Oper

ETR

set etr

Use the set etr command to enable or disable Emergency Transfer Relay (ETR) mode, or to
allow the gateway to control ETR mode automatically.
Note:
If a call is in progress when the communications problem ends, the gateway does
Note:
not turn off ETR mode automatically. If you specify manual-off, the call
terminates.
Syntax
set etr module {auto | manual-on }
390 Avaya G450 CLI Reference
Description
Send flow-control operation mode. Possible modes:
On — indicates that the local port will send flow control frames
to the far end.
Off — indicates that the local port will not send flow control
frames to the far end.
Receive flow-control administration. Possible settings:
On — indicates that the local port will act upon flow control
indications if received from the far end.
Off — indicates that the local port will discard flow control
frames if received from the far end.
Receive flow-control operation mode. Possible modes:
On — indicates that the local port will act upon flow control
indications received from the far end.
Off — indicates that the local port will discard flow control
frames received from the far end.
ETR
2 of 2