Show Controllers Remote - Avaya G450 Cli Reference Manual

Data in current interval (802 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 802 Unavail Secs
Total Data (last 4 15 minute intervals):
10 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 1 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 3600 Unavail Secs
Related Commands - E1/T1 interfaces
clear controller
source, ds-mode, fdl, framing,
loopback, remote,
Related Commands - Verifying WAN configuration
show frame-relay
traffic, show interfaces,

show controllers remote

Use the show controllers remote command to display controller statistics from a peer
station. If the Facility Data Link (FDL) for this controller is set to att, the system displays the
status (up or down) of the line. Otherwise, the system displays statistics for the controller. To set
the Facility Data Link, refer to
Syntax
show controllers remote module/port fdl_data_type
Parameters
Parameter
module
port
fdl_data_
type
User Level
read-write
counters, controller, cablelength
interface
show controllers remote,
fragment, show frame-relay
show ip interface,
fdl on page 363.
Description
The module number
The port number
The type of statistics to
display
long, cablelength
serial, ip address, linecode
show ds-mode
lmi, show frame-relay
show map-class frame-relay
Possible Values
1h-data,
errored-esf-data,
enhanced-1h,
enhanced-c1-configuration
E1/T1 interfaces
short, channel-group,
(E1), linecode (T1),
pvc, show frame-relay
Default
Value
Issue 1 January 2008
clock
373