Set Port Duplex - Avaya G450 Cli Reference Manual

CLI Commands
Example
To specify that port 6/5 will advertise asymmetric Tx pause capabilities only:
G450-001(super)# set port auto-negotiation-flowcontrol-advertisement 6/5
asym-tx-only
Port 6/5 pause capabilities was set
Related Commands
set port duplex,
level, set port
show port auto-negotiation-flowcontrol-advertisement,
flowcontrol

set port duplex

Use the set port duplex command to configure the duplex type of an Ethernet or Fast
Ethernet port or range of ports. You can configure Ethernet and FastEthernet interfaces to either
full duplex or half duplex.
The duplex status of a port in auto-negotiation mode is determined by auto-negotiation. An error
message is generated if you try to set the transmission type of auto-negotiation Fast Ethernet
ports to half-duplex or full-duplex mode.
Syntax
set port duplex module/port {full|half}
Parameters
Parameter
module
port
full
half
User Level
read-write
376 Avaya G450 CLI Reference
set port edge admin
name, set port negotiation,
Description
Number of the module
Number of the port on the module.
You can also specify a range of ports
separated by a dash, for example, 10/5-6 for
both ETH LAN ports 5-6 on the front panel.
Keyword specifying to set full-duplex
transmission
Keyword specifying to set half-duplex
transmission
state, set port enable |
set port point-to-point admin
show port edge
Ethernet port configuration
disable, set port flowcontrol,
status, set port
state, show port
Possible Default
Values Value
set port
speed,