Show Rtp-Stat Traceroute - Avaya G450 Cli Reference Manual

CLI Commands
Average Remote Loss
RTT
Local Jitter
Remote Jitter
SSRC Changes
Note:
For an explanation of the output fields, see the table describing the output of the
Note:
show rtp-stat thresholds command in the chapter Configuring monitoring
applications, in Administration for the Avaya G450 Media Gateway, 03-602055.
Related Commands
rtp-stat clear, rtp-stat
rtp-stat qos-trap-rate-limit, rtp-stat-service,
detailed, show rtp-stat

show rtp-stat traceroute

If the RTP statistics application is enabled (see rtp-stat-service), the G450 VoIP engine issues a
UDP traceroute for every active RTP session. The traceroute is performed 10 seconds after the
session begins. A traceroute is not performed if there is another active session to the same
destination for which a traceroute was already performed within the last 5 seconds. Use the
show rtp-stat traceroute command to display the automatic session traceroute result.
You can filter the results according to subnet address or rtp-statistics session index.
Syntax
Show rtp-stat traceroute [{session session-id] | destination-ip
remote-subnet remote-subnet-mask [last Last-N]}]
Parameters
Parameter
session-id
remote-subnet
remote-subnet-
mask
918 Avaya G450 CLI Reference
3.0%
500mS
50mS
50mS
N/A
event-threshold, rtp-stat
rtp-stat
sessions, show rtp-stat
Description
The index of a specific RTP
statistics session
The remote subnet address
The remote subnet mask
N/A
1
1
1
1
fault, rtp-stat min-stat-win,
threshold, show rtp-stat
summary, show rtp-stat traceroute
Possible Values
RTP statistics
rtp-stat qos-trap,
config, show rtp-stat
Default Value