Dynamic Cac - Avaya G450 Cli Reference Manual

Dynamic CAC

dynamic-cac
Use the dynamic-cac command to set the dynamic CAC bearer bandwidth limit for the current
interface. You can also specify an activation priority for the interface. In case more than one
interface with a BBL value is up, the G450 reports the BBL of the interface with the highest
activation priority.
Syntax
[no] dynamic-cac bbl [activation_priority]
Parameters
Parameter
bbl
activation_
priority
User Level
read-write
Context
interface:Serial (DS1 PPP L2, DS1 PPP L2-L3, DS1 FR-SUB L2, DS1 FR-SUB L2-L3,
USP PPP L2 USP PPP L2-L3,), FastEthernet (L2, L2-L3, PPP L2, PPP L2-L3), Tunnel (L2,
L2-L3), Dialer (L2, L2-L3), Loopback (L2, L2-L3), VLAN (L2, L2-L3)
Example
To set dynamic CAC on FastEthernet interface 10/2, with a bearer bandwidth limit of 128 and an
activation priority of 100:
G450-001(super-if:FastEthernet 10/2)# dynamic-cac 128 100
Related Commands
show dynamic-cac
Description
The bearer bandwidth for the current
interface
The priority value of this interface
Dynamic CAC
Possible Default
Values Value
0-100,000,000 -1
Kbits/sec
1-255 50
Issue 1 January 2008 353