Set Endpoint-Init - Avaya G450 Cli Reference Manual

CLI Commands
Related Commands
bri, clear bri, set
set interface, set
spid-b, set sls,

set endpoint-init

Use the set-endpoint-init command to determine whether or not the far-end supports
endpoint initialization in SLS.
Note:
This command is valid only for a BRI circuit employed with ISDN.
Note:
Syntax
set endpoint-init {yes | no}
Note:
The default for this command is no.
Note:
User Level
read-write
Context
sls > bri
Example
To determine that the far-end does not support endpoint initialization:
G450-001(sls-bri <port address>)# set endpoint-init no
Related Commands
bri, clear bri, set
directory-number-b,
side, set spid-a,
930 Avaya G450 CLI Reference
bearer-capability, set
interface-companding,
set tei-assignment, show
bearer-capability, set
set interface, set
set spid-b, set sls, set
country-protocol, set directory-number-a,
set layer1-stable, set
bri, show (bri), show
country-protocol, set
interface-companding,
tei-assignment, show
SLS survivability
set
name, set side, set
sls, sls
directory-number-a, set
set layer1-stable, set
bri, show (bri), show
endpoint-init,
spid-a, set
name, set
sls, sls