Rtp-Stat Fault - Avaya G450 Cli Reference Manual

CLI Commands

rtp-stat fault

Use the rtp-stat fault command to configure the RTP statistics application to send QoS
fault and/or clear traps. A QoS fault trap is sent when a specified number of active RTP
sessions have QoS indicators over the configured thresholds. A QoS clear trap is sent after a
QoS fault trap when the number of active RTP sessions with QoS indicators over the configured
thresholds reduces to a specified number. QoS fault and clear traps are enabled by default.
Syntax
rtp-stat fault
[no] rtp-stat fault
Parameters
Parameter
fault
clear
User Level
read-write
Context
general
Example
To set the fault trap boundary to 1 and the clear trap boundary to 0:
G450-001(super)# rtp-stat fault 1 0
The fault trap boundary was set to 1 (default: 3)
The clear trap boundary was set to 0
Related Commands
rtp-stat clear, rtp-stat
qos-trap-rate-limit, rtp-stat-service,
detailed, show rtp-stat
traceroute
904 Avaya G450 CLI Reference
[fault [clear]]
Description
The fault trap boundary. If the number of
active sessions with QoS faults reaches the
fault trap boundary, a QoS fault trap is sent.
The clear trap boundary. If the number of
active sessions with QoS faults reduces to
the clear trap boundary after a QoS fault
trap was sent, a QoS clear trap is sent.
event-threshold, rtp-stat
rtp-stat
sessions, show rtp-stat
min-stat-win, rtp-stat
threshold, show rtp-stat
summary, show rtp-stat
RTP statistics
Possible Default
Values Value
1-100 3
0-99
qos-trap, rtp-stat
config, show rtp-stat
thresholds, show rtp-stat