Tcp Source-Port - Avaya G450 Cli Reference Manual

CLI Commands
Related Commands - Policy
composite-operation, destination-ip,
dscp-table, show isdn bri
udp source-port
Related Commands - VPN
description (ip
icmp, ip crypto-list, ip-protocol,
show ip crypto-list,

tcp source-port

Use the tcp source-port command to define a source port with the TCP protocol for which
to apply the current rule.
Use the no form of the command to set the TCP source port to
the protocol is set to TCP and the destination port is set to its default value.
Use the not form of the command to specify that the rule applies to all TCP ports other than the
requested ports. If the protocol is not TCP, the protocol is set to TCP and the destination port is
set to its default value
Note:
Issuing this command also sets the protocol to be TCP, if it is not already.
Note:
Syntax
[not] tcp source-port any | {{eq | lt | gt} {port_name | port_number}}
| {range start_port end_port}
no tcp source-port
Parameters
Parameter
any
eq
lt
784 Avaya G450 CLI Reference
link, source-ip,
rule), destination-ip, dscp (policy-based routing, packet sniffing,
ip-rule
tcp source-port, udp
Description
Keyword that specifies to apply the rule to a port
with any name or number
Keyword that specifies to apply the rule to a port
whose name or number matches exactly to the
specified name or number
Keyword that specifies to apply the rule to a port
whose name or number is less than the specified
name or number
dscp (policy), icmp, show
tcp established, tcp
(VPN), local-address,
destination-port, udp source-port
Policy-based routing
composite-operation,
source-port, udp destination-port,
VPN), fragment,
protect crypto map, source-ip,
. If the protocol is not TCP,
any
Possible
Values
show
Default
Value